Putting Your Best Foot Forward: A Step-by-Step Guide to Testing the Fit of Your Safety Footwear

Written By Supertouch
Putting Your Best Foot Forward: A Step-by-Step Guide to Testing the Fit of Your Safety Footwear

Step one: Put a sock in it


It might sound obvious, but before trying on a pair of safety boots, make sure you have the right socks on - these should be the type you intend to wear on the job so that you can accurately assess the boot ’s fit. Ideally, you want socks that are long lasting and insulating, but a top tip is to look for socks with the addition of moisture wicking fabrics which allow the foot to breathe and keep moisture at bay.


Step two: You ’re swell


Make sure you test the boots at the end of your day, as this tends to be when your feet are at their largest, due to swelling.


Step three: If the shoe fits


Before you lace up, push your feet forward and see if you can fit one finger behind your heel. This is a good indication that you have selected the correct size as a shoe any smaller is likely to create circulation issues.


Step four: Keeping you on your toes


Once your boots are on and done up, start walking around, then try some knee raises, as well as hopping and squatting. Next, slowly roll onto the sides of your feet, your ankles should feel adequately supported by the boots at this angle. Completing a variety of different movements like these, helps replicate some of the physical exertions you will be putting your feet and shoes through throughout the course of the day. Be aware that the heel should never lift up out of the boot or rub against the back of the shoe.


Step five: No mean feet


Next, take your feet out of the boots. Are there any red marks? If so, this highlights pressure points and hot spots, meaning that the boots are not a good fit and will likely cause all sorts of painful problems in the future. However, if your feet are free of marks, you ’ve found the fit for you.


Step six: These boots are made for walking


Finally, the last step to take. Once you have tried and tested the boots, we recommend lacing them in a Heel Lock pattern. This not only keeps your feet secure, holding your heel in place and ensuring your ankle is sufficiently supported, but also acts to remove the pressure from the front of your boot.


View our range of Aimont safety shoes